FAQs & Support

PS2 Version

IMPORTANT INFORMATION
Rugby League 2 game may not work properly or may not work at all on Playstation 2 consoles which have been modified with a chip. The game will load and play correctly if the chip is switched off. The most common ways of doing this are:

Method 1 - Most modifications:
1. Put game disk into console, close tray, and switch console into standby mode using Reset button (so red light is visible)
2. Hold down the Reset button on the console until the blue light on the console shows (ie hold for about 3 seconds)

Method 2 - DMS 3:
1. Put game disk into console, close tray, and switch console into standby mode using Reset button (so red light is visible)
2. Hold down the "Square" button on Joypad 1, and press Reset button to start console. Continue to hold the "Square" button until game loads

Method 3 - DMS 4 toxic:
1. Put game disk into console, close tray, and switch console into standby mode using Reset button (so red light is visible)
2. Hold down the "L1" button on Joypad 1, and press Reset button to start console. Continue to hold the "L1" button until game loads

Method 4 - Matrix Infinity/Modbo/NH9:
1. Put game disk into console, close tray, and switch console into standby mode using Reset button (so red light is visible)
2. Hold down the "Start" button on Joypad 1, and press Reset button to start console. Continue to hold the "Start" button down until the writing "DISABLED" appears on the screen
3. Press the Reset button once

Method 5 - Messiah 1:
1. Put game disk into console, close tray, and switch console into standby mode using Reset button (so red light is visible)
2. Press the reset button to turn the machine on, and then quickly double press the Reset button again.

Method 6:
1. Put game disk into console, close tray, and switch console into standby mode using Reset button (so red light is visible)
2. Press and hold the 'Eject' button for at least 5 seconds 3. Close the tray by pressing the 'Eject' button again

If these methods are not successful, please contact the person who installed the chip for instructions on disabling it temporarily to play the game.

For further information visit www.trublu.com.au

If you are still having problems, please email support@trublu.com.au

PC Version

Minimum System requirements for the PC version
PIII 500MHz
128MB RAM
32MB 3D DirectX 8.1a compatible accelerated video card
16 Bit DirectX 8.1a compatible Sound Card
850MB of Hard Drive Space
Windows 98SE, 2000*, XP*
CDROM drive
*With latest service pack

Recommended System requirements for PC version
P4 1.3GHz
256MB RAM
64MB 3D DirectX 8.1a compatible Texture & Lighting video card
16 Bit DirectX 8.1a compatible Sound Card
850MB of Hard Drive Space
Windows 98SE, 2000*, XP*
24x CDROM drive
*With latest service pack